![]() I found a check box in code wizard that was supposed to toggle on inverse time. None of which seem to be in Degrees per minute. Hurco has Inverse Time Feedrate (G93), Feed Per Minute Feedrate (G94) and Feed Per Revolution Feedrate (G95) available. I think the F900ish command from edge post is in Deg/min, so take approximately 3 turns in one minute is what it means. ![]() I've rarely had the time to visit this as it doesn't occur too often and everything is always in a hurry. Sent me down a rabbit hole trying to understand Degrees per minute vs Inverse time etc. The output on the A axis move was a full rotation on 10in dia with F900.0 (roughly). ![]() This bit me lately as I would post out code and input feed rate of 100ipm and when the mill engaged the rotary portion of the program the rotary took off at basically a rapid feed rate. I regularly run rotary axis programs, and have never taken the time to understand the actual feed rate commands.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |